STYLO
Incalzitor

STYLO electric convector can be used as an auxiliary heating of offices and flats, but it is also a good solution to use it as a basic heating. Its appearance is elegant, it is energy saving, so you can heat premises at a low cost where there isn’t central heating installed.

The filament of the STYLO electric convector is an X-profiled aluminium body. It works at a lower temperature at filaments, so its operation is more economical compared to traditional convectors. Hot air doesn’t arise directly, but flows in perpendicular direction for a while because of the guide-channel on the top of the device.

The STYLO can be installed easily and quickly, and it starts heating immediately after connecting it to the electrical networks (if the thermostat senses lower temperature than you have set before). Thanks to the built-in intelligent control thermostat, the STYLO heats up the air quickly then stops at the needed temperature. As the temperature of the air falls under the temperature you have set before, the STYLO activates itself and starts to heat. Due to this temperament, you can save a lot of money and energy. You can regulate the temperature from 5 °C to 28 °C where the thermostat is placedWhere the thermostat is placed. STYLO electric convector has 8 settings, each means a 2-3 °C degree temperature increase. If the temperature falls under 5 °C, the device activates itself automatically to prevent freezing, and stops above 28 °C in order to prevent overheating.

However, if the premise would overheat even so, the convector activetes itself again after the premise becomes cooler. Besides conventional heating, the surface of the steel emits infra rays. This contributes to increasing the feeling of comfort and to heating the premises more quickly.


STYLO 500
STYLO 500
STYLO 1000 STYLO 1500 STYLO 2000
Dimensions 470 x 410 x 75 mm 710 x 410 x 75 mm 960 x 410 x 75 mm 1160 x 410 x 75 mm
Weight 3,9 kg
5,65 kg
7,15 kg
8,6 kg
Power supply 220-230V ~50-60Hz 220-230V ~50-60Hz 220-230V ~50-60Hz 220-230V ~50-60Hz
Total Consumption 500 W 1000 W 1500 W 2000 W
Switcher Thermostat Thermostat Thermostat Thermostat
Heated area 6-8 m2 12-15 m2 17-20 m2 21-25 m2
IP protection IP 24 IP 24 IP 24 IP 24
Insulation class II. II. II. II.

 

* The calculated value is between 2.5 and 3 meters height, and depend on climate and thermal insulation of the room.

 

 

THE PRODUCT IS NOT EQUIPPED WITH POWER CABLE AND FIX SOCKET.
You can connect the device to the power supply directly or install a socket. The electric connection must be done by a professional.

THE PRODUCT IS NOT EQUIPPED WITH POWER CABLE AND FIX SOCKET.

You can connect the device to the power supply directly or install a socket. The electric connection must be done by a professional.

 

STYLO electric convector

STYLO electric convector

STYLO electric convector

Downloads pe teme asemănătoare:


AVIT d.o.o.  •   Novosadski put 62, 21203 Veternik
Tel: +381 21 64-10-160  •  +381 21 820-416  •  381 21 820-681  •  Fax: +381 21 64-10-159


AVIT d.o.o.  •   Bulevar Arsenija Čarnojevića 70, 11070 Novi Beograd
Tel/Fax: +381 11 3122-559


Sva prava zadržana. Tehnički podaci, slike i crteži objavljeni na našim stranicama su isključivo informativnog karaktera. Slike na sajtu su ilustracije. O tačnim podacima se možete informisati kod naših inženjera. Zadržavamo pravo promene podataka.

Copyright © 2010 Avit doo